Hi.
I have Xentry 12.2022 installed (Open Shell). Connected to MB W204 (c class).
Xentry stareted some sort of update (might be multiplexer firmware-not sure) and then short scan begun. All good,scan finished,showed me fault codes and then I disconnected it from a car (after cleaning fault codes).
Friend took it for a 1 hour drive and then I connected SDC4 back to car and Xentry would not connected anymore.
Communication error (1.?.?) - in yellow colour.
It would not see the multiplexer in toolkit apart from only number 01 - which is the number of mu device. Can't do update ... C4 power up properly.
Any sugestions please ???
Thanks.
I have Xentry 12.2022 installed (Open Shell). Connected to MB W204 (c class).
Xentry stareted some sort of update (might be multiplexer firmware-not sure) and then short scan begun. All good,scan finished,showed me fault codes and then I disconnected it from a car (after cleaning fault codes).
Friend took it for a 1 hour drive and then I connected SDC4 back to car and Xentry would not connected anymore.
Communication error (1.?.?) - in yellow colour.
It would not see the multiplexer in toolkit apart from only number 01 - which is the number of mu device. Can't do update ... C4 power up properly.
Any sugestions please ???
Thanks.