PSA DIAGBOX, can you use bosch mts 6531 or only genuine lexia is supported?

[bladest]

Hi can someone tell me where and how to change PSA DIAGBOX interface , can you change interface and use bosch mts 6531 or only genuine lexia and chinese vxdiag are supported?

[mattydr67]

Try like this:
Install drivers for your interface
Reboot the computer.
Plug the interface to the USB and to the car.
Put the key to start but do not start the engine.
Run Diagbox.
When it will try to connect to the car the Diagbox will pick it up ( choose ) the interface that it is plugged to the USB and to the car in that moment and it will try to connect.

Good luck

[bladest]

Hi thanks but on the diagbox i dont see any option on the settings to change interface i already have vxdiag and other interfaces i want to see if my bosch 6531 will be able to read and see more modules compared to vxdiag or will it work at all with diagbox,did you test it ?

[mattydr67]

If you are reading carefully what I said in my post above you will understand that Diagbox will choose by itself which interface will use. There is no setting  where you cant set one or another interface.
You can try any interface you want. You will see if it is agreed by Diagbox and the most important to communicate with the car.

Good luck