+- AutoProfessionals (https://www.autoprofessionals.org)
+-- Forum: Auto-Professionals Cars Forums (https://www.autoprofessionals.org/forumdisplay.php?fid=9)
+--- Forum: Vehicles Problems & General Discussions (https://www.autoprofessionals.org/forumdisplay.php?fid=76)
+---- Forum: Mercedes Benz (https://www.autoprofessionals.org/forumdisplay.php?fid=93)
+---- Thread: W204 Auto Transmission (/showthread.php?tid=4035)
W204 Auto Transmission - malguy - 18-02-2016
Good day guys,
Need some advise here, I have a C200 W204.048 with 722.696 trans at my shop now with transmission slip & lock to third gear. I diagnose with star and come up with fault code 0730 & 0733, I also found that the adaptor for electro plate is leaking atf. I replaced both with new filter & fluid.
Now it only shift to second gear & come fault code 1731, anyone here seen this before ? I have also check the TCU, all dry & clean inside.
Any help would be much appreciated. I am tearing apart the trans now to see if there is any mechanical failure.
Thanks.
Best regards,
RE: W204 Auto Transmission - malguy - 19-02-2016
Thanks for input, after open this gearbox, we found input shaft, disc support & freewheel bearing are badly worn, friction plate have burn mark. But fluid lever are normal, maybe low on fluid for sometimes before owner send car to me.
Any suggestion what have cause this ?
Thanks.
Regards,
(18-02-2016, 20:12)Pavlik072 Wrote: посмотри параметры вращения скорости датчиков, турбины и промежуточного вала: промежуточный вал показывает скорость с 2 передачи и далее, а так сгорел или нет контакта на датчик скорости промежуточного вала
RE: W204 Auto Transmission - lashe - 16-06-2020
at this point
best you replace whole tranny
and use old VGS
it will make all stress easier time more useful
cheers
RE: W204 Auto Transmission - markyr17 - 16-04-2021
(18-02-2016, 00:42)malguy Wrote: Good day guys,
Need some advise here, I have a C200 W204.048 with 722.696 trans at my shop now with transmission slip & lock to third gear. I diagnose with star and come up with fault code 0730 & 0733, I also found that the adaptor for electro plate is leaking atf. I replaced both with new filter & fluid.
Now it only shift to second gear & come fault code 1731, anyone here seen this before ? I have also check the TCU, all dry & clean inside.
Any help would be much appreciated. I am tearing apart the trans now to see if there is any mechanical failure.
Thanks.
Best regards,
Curious what you ended up doing in this situation?