Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
X-Horse MVCI connect consult 3 plus
#1
Nissan 
Anyone know, Is there possible to connect X-Horse MVCI (Toyota, Honda, Volvo) to NIssan Consult 3 plus software?
What driver should install? Thanks in advance..
Reply
Thanks given by: djodjon
#2
try toyota
"LIKE"&"THANKS" will increase the motivation

Please read this post !!
Reply
#3
(07-15-2018, 10:38 PM)Kukuh Septianto Wrote:  Anyone know, Is there possible to connect X-Horse MVCI (Toyota, Honda, Volvo) to NIssan Consult 3 plus software?
What driver should install? Thanks in advance..

No. Only Toyota well works.
(I didn't check Volvo)
[Image: 2gy4oax.jpg]

Thanks can be expressed in two ways. To press the "Like" and "Thanks" button
You shouldn't write at the forum "Thanks Brother"
Reply
#4
The only way you can fully use the consult 3 plus software is by buying the VI2 VCI. J2534 even on top quality interface such as cardaq is very basic fault codes only.
[Image: 2gy4oax.jpg]
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)