To obtain your registration ID "Invitation Code", please send your request to: autoprofessionals@mail.ru


ITCDiag
OBD2 Buy, OBD2, OBDII, OBD, car diagnostic, truck scanner, workshop, Chip tuning, fault code reader, IMMO
obdresource
xcar360

DiagPro3

 
Donate and Help Forum

After DONATION send EMAIL to ADMINSTRATOR HERE.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Does Consult III plus V...X need licence?
#1
Hi there... I´m using Consult III V71.20.00 with Pplus V71.4 but reprogramming button is not enabled and data stream either... Do I need to give or generate a licence for this software? ...to get those functions?

Any help?... Thanks in advance

Regards
Reply
Thanks given by:
#2
(05-24-2018, 08:52 PM)pedriux Wrote:  Hi there... I´m using Consult III V71.20.00 with Pplus V71.4  but reprogramming button is not enabled and data stream either... Do I need to give or generate a licence for this software? ...to get those functions?

Any help?... Thanks in advance

Regards

No license is required for this software

If you need advice
Please write more detailed situation
OS
Interface
Screenshot of trouble
etc
Excellent members will advise the solution
"LIKE"&"THANKS" will increase the motivation

Please read this post !!
Reply
Thanks given by: jahacmm , Administrator , muftah76 , kikis , Mister_ACE
#3
OS Windows 7 Ultimate 32 bits
Interface: VCX Diag (Chinese Ford VCM II)
Reply
Thanks given by:
#4
(05-24-2018, 11:27 PM)pedriux Wrote:  OS Windows 7 Ultimate 32 bits
Interface: VCX Diag (Chinese Ford VCM II)

Are you installing the programming version you need?
"LIKE"&"THANKS" will increase the motivation

Please read this post !!
Reply
Thanks given by: jahacmm , Administrator , muftah76 , kikis , Mister_ACE
#5
You need to buy a very expensive Security card and place it in your pcmcia slot.

OR...

Try this...

Find the CONSULT DiagnosticTool.ini file...

Example. C:\CONSULT-III_plus\System\Application\ApplicationData\CommonSetting\DiagnosticTool.ini

Open with notepad...

Copy and Paste this at the bottom...
--------------------------------------------------------
[mode]
debug_mode=TRUE
debug_mode_vehicle-battery=TRUE
[vehicles]
tab_index=0
---------------------------------------------------------
ALSO, MAKE SURE ACCESS_MODE IS SET TO 1 IN THIS FILE

NOW SAVE AND REOPEN CONSULT... DONE! :D
[Image: 2gy4oax.jpg]
Reply
#6
Yes I Did
Reply
Thanks given by:
#7
I think you will need to use a genuine or clone Consult interface to use these features. Your clone VCMII is very poor quality and even for Ford IDS software you will have problems with module flashing and PATS security functions.
[Image: 2gy4oax.jpg]
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)