Latest news: --- HELP:OpenShell.XDOS.2018.07 --- MB VM EPC_WIS 06.2018 --- Some radio code calulators --- PET2 Update 4650 Multilingual is availeble --- Mahindra i-Secure v.2.0, Single Step Immobiliser Tool V 18, etc. --- Mahindra i-Smart --- ECU Software --- Renault radio code --- X-Horse MVCI connect consult 3 plus --- spanishestimate07.2018 --- BOSCH ESI[tronic] 2013/3 (DVDU2) looking for --- JLR SDD V 153.06 Newest Update Install & Active (Jaguar & Land rover) --- Linde Service Guide v6.2.0 --- Easydiag X431 --- Thread Modes Renault CLiP Version 179 FULL Multilanguage --- PET2 Update 4640 Multilingual is availeble --- New KIA I-AVN 2018 FW And Map update. --- New KIA GEN 2.X.X 2018 FW and Map update. --- Rogue --- CM850 AAJ ---
To Obtain Your Registration ID "Invitation Code", Please Send Your Request To:

OBD2 Buy, OBD2, OBDII, OBD, car diagnostic, truck scanner, workshop, Chip tuning, fault code reader, IMMO



Donate and Help Forum


Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
search: read edc7uc31 EEprom
Hi,i search for a solution to read and write EEprom (not flash Eprom) from EDC7UC31 Bosch ecu ,
from outside via Kline or CAN without open ECU!

most time i work with CNH, Sisu, Deutz, Fendt, FPT ...
pls send pm
Thanks given by:
Sorry, we not have this module
Thanks given by: Administrator , Balyanchic , kikis , jahacmm
I think no tool can do this at the moment. only open up ECU.
Thanks given by:
CMD Flash Master. Only KLine.
Thanks given by:

Forum Jump:

Users browsing this thread: 2 Guest(s)